My acquisition.

Quote:

---

Originally Posted by Swarfing

I would make a temporary tank up out of plastic sheet and use the electrolysis method, much safer and will look like new for all the parts. Defo stay away from the sand paper

---

now that sir is a fantastic idea... its been a while since I did this last!

So; youtube...

ok recommends american "Arm and Hammer" soda.... is there any british alternatives?

as the gantry is in the middle (so the cartridges are also in the middle) with rust either side. Il have to do the cartridges aswell? if I have to replace these its no biggies though i guess?

bog standard soda from tesco or where ever is what i use. for the long stuff use long rods for electrodes each side rather than short ones at the end as wel

Electrolysis? Doesn't that need some high current power supplies and the right material for the anode and cathode? I'm not sure what cola has to do with it? Confused here!

Cola? Soda crystals wally :-)

A car charger and steel will do, just need to clean them off once in a while.

Not the sort you want to drink then!

Lol defo not

OK, just a quick update

so, last week I done some experimental electrolysis with small tanks to establish best results.

I stopeed off at the farm on way home from work friday and removed a rail.

Attachment 9026

Stole a bit of gutter off one of my sheds to create a long tank...

Attachment 9027

abra kadabra

Attachment 9028

after 24 hours...

Attachment 9029

Attachment 9030

bearings slide lovely, no play

all back on machine, heavily greased (after this pic)

Attachment 9031

impressive!

Brilliant!!! What a good suggestion Swarfing, and well done for following it through Kingc. G.

Nice one G glad it came out so well, just don't do it on the Ali parts :-)

I'm reluctant to put a piece of sandpaper to anything these day, saves a sh*t load of hard work as well ;-)