Arc Eurotrade stepper

Quote:

---

Originally Posted by Gary

The Datasheet is wrong

---

Now you look at the datasheet when I have 3 of them sitting on my desk :joker:

I did notice the discrepancies, but I have low expectations of rhyme or reason when looking at stepper specs. May be okay, may be lucky they were cheap :rolleyes:

I'll let you know

Robin

I dont think you will have any problems, it is just because AU know little about stepper motors, and have not put the correct info on the datasheet.
Run it in series first at 3A and then try in parallel at 6A, and monitor the temp.

Quote:

---

Originally Posted by Robin Hewitt

Now you look at the datasheet when I have 3 of them sitting on my desk :joker:

I did notice the discrepancies, but I have low expectations of rhyme or reason when looking at stepper specs. May be okay, may be lucky they were cheap :rolleyes:

I'll let you know

Robin

---