UC300 with UB1 will cost 320$ with out shipping and taxes,this is far away from badget right now.....:devilish:
Printable View
UC300 with UB1 will cost 320$ with out shipping and taxes,this is far away from badget right now.....:devilish:
I feel your pain, that's why I setup with PP BOB originally as the budget just wouldn't stretch over Xmas period so I could play with it, do some calibration and decide if I got on with linuxcnc before spending £300 on hardware which locks me into a vendor I haven't even tried.
I remember you saying you've used mach before so being locked in is probably not an issue to you.
When I was able to sell a kidney I got my electronics ;)
Ironically now I have a machine with good latency I can run it at 9m/min no issues from the PP BOB with 8 microsteps which has made the mesa less essential but obviously I'm still going to use it.
Yes you remember correctly,I am going to use Mach3 again.
My new senario is to take the uc300eth-5LPT and a crap break out board until I decide which of two kidney to sell,haha!!
You can also sell one of your eyes and part of your liver ;)Quote:
Originally Posted by Nickhofen
Ahahahhahaa!Quote:
Originally Posted by Desertboy
I need both my eyes for my job,but I have a big nose that I can partially sell to get money for my bob....:-P
I "see" the bob problem coming and finally fix it!!!
Attachment 24097
Hahaha photo from cnccook book!
Sometimes you have yourself do I really need all that blood ;)Quote:
Originally Posted by Nickhofen
I know exactly what you mean.You ask your self this guestion all the time especially when you build something that you do not know how it is going to come up,or if your build is going to meet your standards.
But it's a fight we have to give:Attachment 24103
I am ready to purchase the pulleys 20 Teeth HTD 5M for XY axis 1:1,at X and Y I use 1610 ballscrews.
At Z I have 1605 ballscrew what rate is recommended to use at the pulleys 1:2 maybe?
With 5mm pitch go with 1:1 ratio. This will give you good balance of speed/resolution.Quote:
Originally Posted by Nickhofen