https://www.youtube.com/watch?v=9W3XrzJN_Wg
moooving :D
Printable View
https://www.youtube.com/watch?v=9W3XrzJN_Wg
moooving :D
Another one Lives. Well done that man.:toot:
It's always nice to see a machine move for the first time:thumsup:
Nicely done !
Thanks for the support! Couldn't have done it without you!!
Tomorrow I'm going to try to verify steps per mm , square the gantry with sensors :)
Dont think I will have time for all limits, all homes, cleaning up the cable jungle in the control cab.
Those things come later, I think spindle is next and then cutting something :D
Skickat från min SM-G955F via Tapatalk
Well done man!!! Excellent work!!!
Looking good !Quote:
Originally Posted by Nr1madman
Verstuurd vanaf mijn SM-A320FL met Tapatalk
Woohoo!!! Nice!!!
Okey, Im now in trouble again after mayor brainfreeze :)
Have routed my homeswitches.
I connected them in parallell.
Brown wire = 24v
Blue wire = gnd
Black wire = signal to bob
If I use this config I get 24v when measuring between black and blue.
If one switch gets close to steel they all light up and the voltage goes to 0 between black and blue.
If I use this paralell connection the bob gets supplied with 24v on the output pin?
Should I instead connect it in series ?
Can't get my mind around this :)
Skickat från min SM-G955F via Tapatalk