Use the CM terminal, not the -Quote:
Originally Posted by D-man
However that wouldn't explain why the spindle isn't spinning.
What's the acceleration value set to? F0.10
Printable View
Use the CM terminal, not the -Quote:
Originally Posted by D-man
However that wouldn't explain why the spindle isn't spinning.
What's the acceleration value set to? F0.10
My Bad, i will go to CM.Quote:
Originally Posted by m_c
F0.10 - 0.8
F0.11 - 0.9
next to these it says that the parameter is related to the inverter model
Depends on Eding outputs and I've never used it so can't tell you. However using relay removes any posibilty of damage and is simple.Quote:
Originally Posted by D-man
quick look at manual shows it's possible to use method I suggested see sec 9.2 it shows simple wiring setup.
If not got relay then for test just setup the 0-10V side and simply short wire between FWD and CM to see if spindle comes to life at the speed set in eding.
Its also worth mentioning that if i unlink CM & FWD the VFD shuts down (Fan goes off etc)
Does the display stay on?Quote:
Originally Posted by D-man
Here is a video of what happens
https://youtu.be/yVzY6sCKhOw
Sent from my iPhone using Tapatalk Pro
That's normal.Quote:
Originally Posted by D-man
what is set in accel setting param f0.10 set it to high number to test try 20
Oh really? So when spindle fires up the fan etc will pop on?Quote:
Originally Posted by m_c
Sent from my iPhone using Tapatalk
So wire up as per picture and change parameters you mentioned and also accel ?Quote:
Originally Posted by JAZZCNC
Sent from my iPhone using Tapatalk Pro