My printer (Sailfish based) can see a directory, but not get into it. I have never found it a problem as I print from root anyway.Quote:
Originally Posted by magicniner
Printable View
My printer (Sailfish based) can see a directory, but not get into it. I have never found it a problem as I print from root anyway.Quote:
Originally Posted by magicniner
I now have uploaded files to the Flashair card in my 3D printer and just warming up to print. (Actually printing now !)
It was a bit of a struggle, but this is the way I have done it :-
The flashair card was updated to the latest firmware and set to AP mode and the alternative web page according to the instructions in
https://mattshub.com/2017/04/11/flashair-sd-card/. Then I used a WIFI USB dongle to connect to the SSID broadcast by the card, in a computer with a wired connection to my network, so I could access my 3D printing files on a NAS drive.
All a little Heath Robinson, but it works and I don't have to keep farting about swapping the SD card between the computer and the printer.
It should be possible to do the same with a USB connection, just using a SD reader plugged into the USB port.
Nice one!
Being it's own access point and so not having any internet-facing connectivity seems like common sense rather than Heath Robinson ;-)
Just as a postscript,(and I know it is not really relevant to this thread) my 3d printer had been playing up on the right extruder. I thought it could be a stepper cable fault, so I replaced the cables to both extruders, which made no difference. On stripping down the hotend, I discovered the thing was choked, so nozzles were put in acetone whilst I waited for the spares I needed to come from Wanhao UK.
Anyway, I got an email acknowledging my order which said they were including a thank-you gift for my past custom.
Todays post brought me the ceramic wraps I needed PLUS an 8GB SanDisk SD card, an all-in-one card reader, a 0.4mm drill, a good quality pair of tweezers and a filament pusher. Did they know it was my birthday last week?
Gobsmacked Rob !
It's nice to know that a company that isn't open source supports their customers ;-)