Yes Neil, here is the reason:
Attachment 17586cable chain took space on other side
Printable View
Yes Neil, here is the reason:
Attachment 17586cable chain took space on other side
Attachment 18136Attachment 18137Attachment 18138Attachment 18139Attachment 18140
So close to the end - Home/Limit X sensor (showing pick up blocks)
Working on Z plate. Many problems with low profile rails - will never buy them again. Original plan was to use 5M belt rather than RM14 ballscrew
Attachment 18161Attachment 18160Attachment 18159Attachment 18158Attachment 18157
Attachment 18156Attachment 18155Attachment 18154Attachment 18153Attachment 18152Attachment 18147Attachment 18151Attachment 18148
Attachment 18149Attachment 18150Attachment 18141Attachment 18142Attachment 18143Attachment 18144Attachment 18145Attachment 18146
Attachment 18567Attachment 18569
All tested - managed to smashed X axis sensor (was sticking out too much and hit the target, another one was flickering when close to target - cheap Chinese sh***t - cost me time replace)
Black oxide kit used to blacken the steel parts - mostly mild or bright steel
Attachment 18575Attachment 18570
Now everything strip down for painting
Attachment 18573Attachment 18571
I use body filler to cover imperfection
Already lost patience and final result not brilliant
Attachment 18576Attachment 18577Attachment 18578Attachment 18579
Looking good Tom.:yahoo:. . . . Now it's time to get dirty. .:onthego:
Is the inductive sensors good for this?Quote:
Originally Posted by Tom J
Why did slow down the steppers?
Nice build Tom.
Thanks for posting
Mike
I do not recommend Chinese sensors, few of them failed before I finish calibration (one I managed to smash)
I tried 2mm and 4mm seems to be no difference in accuracy. I wanted to improve accuracy for homing but there is no difference with decent omron mechanical switch - wasted money in my case.
I use Z18 and Z20 pulley which gives 0.8 gear ratio. Machine mend to mill alloy, so do not need super speed 1400mm/min at 64 microsteps. Might change setting when start cutting P6 alloy or similar.
I use Digital drivers DM 542 - thanks Jazz for advise, much better, smooth, quiet run.
I am not happy with this usb card
Attachment 18740
I lost soft limit function over the night without touching anything - was ok, and now machine is in limit but message says that is out - you can not win.
Homing was ok, now every axis trigger home and have to be reset to do another axis till all done.
Reset has to be pressed twice, so often. I think to come back to DOB 25 and LPT port.