Originally Posted by
Davek0974
Looking at the dimensions more, i can only repeat earlier comments - this is not a machine for what is called "plates and skates" motion - ball bearings running on steel plates. It works reasonably for small stuff - my first plasma cutter was plate & skate but it jammed a lot due to crud on the plates and it was only 650x650mm, over a length of 3000mm the motion will not track square or level.
This would be a big machine, heavy and expensive I feel, it will need to be if it is to do any sort of work at all. If it were me building big, I would be looking at ball screws, 25mm linear rails, 750W servo motors at least, and a heavy steel frame. I would not even go with the round supported rail at this size. Just my thoughts of course. :)