Search:

Eddy
Think what siliavski means is drill the end of the rail along its length offset so you don't intercept a securing bolt drilling, then drill down from the top of the rail to intercept the hole,...

Nice job Eddy, is that a Felder ?
Regards
Mike

Hi Eddy
You will have to drill the 40x160 right through and use stud iron same dia as the slot width, small lengths of flat bar drilled and tapped to fit the 45deg section and you want a hole in the...

OK
What you need is some substantial flat bar (4 off) say 25mm wide and about 10mm thick and about 50mm long,
if the slot in your vice is less than 10mm wide you will need to machine the end of the...

Thanks guys
Did a fresh install but it must have picked up something from my profile file and video would still not work so had a look round and was trying to remove my profile but it recommended...

Hi
Chronos have a pretty good selection.
http://www.chronos.ltd.uk/cgi-bin/sh000001.pl?WD=lathe%20index%20tool&PN=glanze_lathe_tools.html#aCG214
I was fortunate enough to aquire a good selection...

It's a Trappaning Head used to cut holes in thin material, small hole is drilled in material same size as the bottom spigot and machine set to slow speed.
Mike

Hi Neil
Just checked Ken's machine and the DRO reads same as the dials,so you would put half the required amount you want to remove, there will probably be an option in the set up menu, I would...

Hi Martin
Welcome to the forum
A rough idea of your working area requirement would be helpfull.
Unfortunately there is a lot of overpriced junk knocking around on the various auction sites, have a...

Hi Chris
Welcome to the forum
First step have a look @ the build logs oodles of reading to do first. Then download sketchup(free design software) and put down some ideas, the guys will then offer...

If the pitch is metric the leadscrew is Trapazoidal(Trapazoidal is the metric version of Acme)
Not all the pitches are show on the charts i had a look @. I was looking for data for turning an M8 x...

Hi washout
something like this any good Low Profile Clamps
In the Machine shop i used to work in the Millers would have a parallel ground a good fit in the bed slots and use a clamp similar...

Screwcutting Programs

Fireweaver
Welcome to the Forum M8
Have sent you an PM

Very nice Eddy

THK HSR20 Linear bearings & rail L=970mm | eBay

Hi Dan & welcome to the forum, Steel would be the best option for frame construction and if budget allows try to include profile rail as opposed to the round bar stuff, you can get second hand...

Hi M8
That one was listed as out of stock
Buy Axminster CNC 4th Axis Rotary Table from Axminster, fast delivery for the UK
This ones silly money, with a bit of luck someone on the forum will have...

Olsen Engineering - Roller Screw Linear Actuators

Hi Dudz
Try a look @ these SLOT DRILLS
they are used for producing keyways

Hi dudz
I only had a look @ the Elliot as i bought a new Emcomat 7L about 30 years ago,desperately wanted the the V10 but way out of my price range @ the time, my user manual includes the Emcomat 7...

Hi dudz
Just had a quick look @ that and you appear to get a 3 Jaw Chuck as standard, for turning(not milling) square stock you will require the optional extra of the 80mm 4 Jaw Chuck which should...