Speeds and feeds for carbon fibre.

[Dean jeffery]

Well I'm sure you'll see a big improvement with the corn cutters mate, but minimal clean up for me is a big deal and only a few need clean up the first few parts come off needing nothing but a wash.

But when selling parts if they don't look 100% spot on then and rightly so people complain.

[Billythefish]

Good post! Thanks...

how did you hold the carbon sheet? Screw and glue?

cheers, Billy

[Jonathan]

Screws where feasible, double sided tape where not.

[Dean jeffery]

Good post! Thanks...

how did you hold the carbon sheet? Screw and glue?

cheers, Billy

Sorry missed this post I used both DS tape plus screwed

[Dean jeffery]

Lol Jazz that won't no cheapo Chinese cutter though, it was my one and only super plastic cutter :( been replaced by cheapo Chinese to compare

[Flyer]

Looks good Dean, I've just ordered some
How are you cutting the countersinks?

[Dean jeffery]

Sorry flyer I missed this :( I'm doing the countersinks with a coated carbide sim to this one eBay 222222270634 I use an 8mm bit 4 flute.

Machining then I use a profile method 3 passes, doing then in Z caused chattering and was slower :)