Bridgeport Servo Motors--Mach3 Compatible?

[JAZZCNC]

I have been looking at some controllers recently that are reasonably priced and have up to 5 axis capability with rigid tapping too and they have not been too bad in terms of price. I am still trying to verify if they are legal in the EU though.

But do these Chinese controllers your looking at output Analog signals or just Step/Dir.? . . . Most I've seen are Step/Dir.

If was me and DC Servos/drives are working fine then I'd just go with the Cslab's IP-A. Doesn't get any easier just little rewiring and away you go and with top notch controller from Top company.