Not so new introduction

[routercnc]

Hi Rebekah

Welcome to the forum
Fusion 360 is a great bit of software. I'm sure you've found it already but if not check out John on YouTube nyccnc for Fusion Friday hints and examples

[Rebekah_harper]

Hiya routercnc,

I haven't come accross him so I will check him out. I've been watching Lars christiansen who does a great introduction to the software.

I am going to ask about feedrates in this forum as this is the only thing that weighs heavy on my mind.

regards

becky

[routercnc]

Lars is good too. Great thing about John is the enthusiasm and the fact he shows things from a users point of view

[Rebekah_harper]

have you got a link to his videos?

[Clive S]

have you got a link to his videos?

Is this you are looking for:- https://www.youtube.com/watch?v=AMh2TnfPsaY