Threaded View
-
04-08-2016 #28
Last Activity: 08-01-2026
I would normally adjust feed rate to the middle of the green in CAM but it was a one-off job profiling a couple of small ally plates with a new single flute cutter, I realised it could run faster once I started the job so I just wound it up until it felt right rather than going back to CAM.
Originally Posted by John S
- NickYou think that's too expensive? You're not a Model Engineer are you? :D
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Aspire v4.5
By m.marino in forum VectricReplies: 6Last Post: 16-05-2015, 04:44 PM -
CNC router occasionally makes jarring noise and home jumps when it does this. Help!!
By itsmillertime in forum Machine DiscussionReplies: 47Last Post: 13-02-2014, 11:49 PM -
control signals to draw a circle
By lakmalp in forum Machine Control SoftwareReplies: 3Last Post: 16-06-2013, 05:52 PM -
Cutting out a circle
By Martin Paul in forum Machine DiscussionReplies: 2Last Post: 19-04-2011, 12:58 AM -
Aspire !!!
By james mcgrew in forum CAD & CAM SoftwareReplies: 2Last Post: 17-01-2009, 02:16 AM
Bookmarks