. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 04-08-2016 #1
    magicniner's Avatar
    Lives in Rotherham, United Kingdom.
    magicniner
    Last Activity: 08-01-2026 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 2,021. Received thanks 230 times, giving thanks to others 42 times.
    Quote Originally Posted by John S View Post
    Why do you use FRO at 300%?
    I would normally adjust feed rate to the middle of the green in CAM but it was a one-off job profiling a couple of small ally plates with a new single flute cutter, I realised it could run faster once I started the job so I just wound it up until it felt right rather than going back to CAM.

    - Nick
    You think that's too expensive? You're not a Model Engineer are you? :D
    Reply With Quote Reply With Quote
  2. 04-08-2016 #2
    Davek0974's Avatar
    Lives in Bishops stortford, United Kingdom.
    Davek0974
    Last Activity: 20-12-2024 Has been a member for 9-10 years. Has a total post count of 1,165. Received thanks 78 times, giving thanks to others 226 times.
    Is the Mach forum having issues - i have not been able to load it since early yesterday morning???
    https://ddmetalproducts.co.uk
    Reply With Quote Reply With Quote
  3. 04-08-2016 #3
    Ger21's Avatar
    Lives in Detroit, United States.
    Ger21
    Last Activity: 24-07-2022 Has been a member for 9-10 years. Has a total post count of 651. Received thanks 90 times, giving thanks to others 0 times. Referred 1 members to the community.
    Yes, I mentioned it in my previous post.
    Gerry
    ______________________________________________
    UCCNC 2022 Screenset

    Mach3 2010 Screenset

    JointCAM - CAM for Woodworking Joints
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Aspire v4.5
    By m.marino in forum Vectric
    Replies: 6
    Last Post: 16-05-2015, 04:44 PM
  2. CNC router occasionally makes jarring noise and home jumps when it does this. Help!!
    By itsmillertime in forum Machine Discussion
    Replies: 47
    Last Post: 13-02-2014, 11:49 PM
  3. control signals to draw a circle
    By lakmalp in forum Machine Control Software
    Replies: 3
    Last Post: 16-06-2013, 05:52 PM
  4. Cutting out a circle
    By Martin Paul in forum Machine Discussion
    Replies: 2
    Last Post: 19-04-2011, 12:58 AM
  5. Aspire !!!
    By james mcgrew in forum CAD & CAM Software
    Replies: 2
    Last Post: 17-01-2009, 02:16 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules