Threaded View
-
22-07-2016 #5
Hello magicniner & routercnc,
Thank you & very kind of you for your swift reply.
Let me put my issues, very precisely now.
We use Manford CNC Bed Type Milling Machine - Tontec Technology.
Model No : Manford - VM1100 / VM1000.
You can view its specifications in the below URL.
http://www.manford.com.tw/products-v...N&ProductID=42
We run 3 shifts in a day. When the tool bit looses contact with the workpiece,
the CNC machine simply runs. During this time, we want to generate an
alarm (alert) signal & stop the machine automatically, if possible.
We would like to monitor or measure, how much time is wasted in a day for this?
Looking to improve the production capacity with best cost-effective solutions.
How can this be achieved. Can it be done with program alone or any
external hardware is required? Thanks in advance.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
AM882 Alarm and Enable Signal Question
By Gotty101 in forum Motor Drivers & ControllersReplies: 2Last Post: 24-11-2015, 11:07 PM -
Need to slow down a signal due to Safe Torque Off alarm
By corkcnc in forum General ElectronicsReplies: 0Last Post: 04-06-2014, 11:35 PM -
Workpiece illumination
By cropwell in forum Workshop & EquipmentReplies: 0Last Post: 29-09-2013, 10:21 PM -
Securing the workpiece
By jrob3rts in forum Machine DiscussionReplies: 3Last Post: 16-06-2012, 10:21 PM
Bookmarks