Threaded View
-
20-07-2016 #1
Hello, I am Govind from Bangalore, India.
I have a production related issues on our CNC machines.
When the CNC operator does not keep the work-piece material properly on the machine bed or worktable, the machine simply runs and the time get wasted. After realizing the mistake, the operator keeps it properly and re-run the machine. It happens especially during night shift, and the production capacity affects.
Is there any solution (programming or sensor related) to avoid such mistakes?
If the work-piece material is improperly placed on the machine bed or worktable,
the machine should give an alarm signal (warning) to the operator, so that he can immediately rectify it. How to achieve this? Any practical solution for this problem? Thanks in advance.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
AM882 Alarm and Enable Signal Question
By Gotty101 in forum Motor Drivers & ControllersReplies: 2Last Post: 24-11-2015, 11:07 PM -
Need to slow down a signal due to Safe Torque Off alarm
By corkcnc in forum General ElectronicsReplies: 0Last Post: 04-06-2014, 11:35 PM -
Workpiece illumination
By cropwell in forum Workshop & EquipmentReplies: 0Last Post: 29-09-2013, 10:21 PM -
Securing the workpiece
By jrob3rts in forum Machine DiscussionReplies: 3Last Post: 16-06-2012, 10:21 PM
Bookmarks