Recommendations for Z Axis?

[samsagaz]

Even so, you should aim at least at ~200 ipm / 5000 mm/min as absolute minimum. I would say you should aim at 10000 mm/min for a "normall" machine.


Not that you will cut at those speeds but machine needs to be "snappy" with good acceleration. Which is sth i believe you have not considered. At the beginning i was also not aware of that fact. Good that people pointed that to me. Otherwise some jobs will take eternity , too much time even for home.

Now having that in mind, do some research about the efficiency of stepper motors, your load, the motors. Under load it will have only a couple of hundred useful RPM. So do your calculations from this.


What size will be your machine???

Gracias nuevamente amigo!!!!

Here i attach the sizes of the actual draw



(Sorry for my english)