Thread: Sirel/MAC DC Motor Driver
-
25-10-2016 #1
Does anybody have ANY information about the Sirel / MAC F9306B spindle driver pinout?
I considered using my MAC driver (same as Sirel F9306B) for a while before i decided for a replacement driver motor combination With my CSMIO/TP-S Controller.
I know how it was Connected to the old processor unit, but not quite sure if it will be compatible With the CSMIO Controller.
Haven`t got the foggiest idea about the pinout definitions on the old Mac Controller, but here is a draft of how it was set up previously.
Output to motor(Parker RS520GR1000) is 20.7 to 107VDC.
I have not idea about the meaning of abbreviations CB-B, VAL, -DOK, +DOK or VB(second channel B?).
I do however believe 0 to be 0V in association with +12V and -12V... in think..
Any good ideas or tips?
Regards
Last edited by Proteus; 25-10-2016 at 08:11 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Boxford VMC 300 Sirel Spindle Drive and motor
By Joe in forum Boxford Vertical MillsReplies: 0Last Post: 12-08-2015, 07:46 PM -
Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 07:29 PM -
New SCR driver board, or new motor & VFD?
By m_c in forum Motor Drivers & ControllersReplies: 2Last Post: 04-11-2010, 05:16 PM -
Motor & Driver setup
By action-kat in forum General ElectronicsReplies: 8Last Post: 19-07-2010, 11:24 AM -
Stepper Motor Driver v2.3 2A $20 !!!
By Lee Roberts in forum Motor Drivers & ControllersReplies: 15Last Post: 17-05-2009, 10:57 PM
Bookmarks