Quote Originally Posted by magicniner View Post
The smaller diameter range non-reversible jaw set on self centring chucks still have steps on the outside for gripping the inside of cylindrical work, it's more common on smaller chucks that just one reversible set is supplied.

A quick and easy way to check is that the teeth which engage the scroll will have symmetrical inner and outer faces if the jaws are reversible,

- Nick
Thanks. I dont think this one is reversible. Pity, I need around 100mm and only have 85 or so.

ATC works. Got an idea how to do offsets but not sure how you 'centre' a drill.

The spindle is being given controls via RS485. It doesnt work on power up. Enable the plugin for the VFD, it works but trips (kicks out reset on software). Then disable the VFD plugin, it works without a problem. That said, it spins the wrong way initially then the correct way. The speed inputs also dont seem to work well. Might need to reset this setup and start again.

Any thoughts?