Quote Originally Posted by m_c View Post
Have you tried running the lathe with a voltmeter (an oscilloscope would be better) on the powersupply to see how it's handling the load?

If you were getting good enough performance with 24V, I probably wouldn't be inclined to bump it up that much. I'd probably aim around 30-40V, but it would really depend on what the motors could handle. Remember higher voltage just means better performance at speed. At low speed it won't make much, if any difference.
Nope, but was going to do that.

The current ability of the PSU is 10A (in theory), the same as it replaces. Its Ok with slow speed, its when I try to rapid that it tends to struggle. Ill take a closer look this weekend.