Threaded View
-
13-09-2019 #20
Don't know what to say Boyan.
I have been using the same one on my test CNC builds (all of them) using a variety of steppers and aside from EMI shielding (which is a problem with almost every controller and USB, so I switched to ethernet right fast) I have had 0 issues.
I did use their stepper drivers though, those were just an amazing help as you can actually connect them over USB too and set them up in so many ways and test your steppers.
But even with hybrid servos it works.
Oh one other thing, I use Mach 4. Maybe that also plays a role.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Step-Four problems
By BazzerH in forum General DiscussionReplies: 8Last Post: 18-03-2020, 11:09 PM -
Mach3 Problems problems problems.
By ECCO in forum Artsoft Mach (3 & 4)Replies: 18Last Post: 09-07-2016, 10:07 AM -
Help needed! Servo, MACH3 or Pokeys57CNC whats going on?
By Boyan Silyavski in forum PoLabs (PoKeys)Replies: 5Last Post: 23-06-2016, 04:22 PM -
tree problems!
By kingcreaky in forum Woodwork DiscussionReplies: 8Last Post: 02-06-2014, 12:35 PM -
NEW MEMBER: MDF Problems
By MrWiz73 in forum New Member IntroductionsReplies: 4Last Post: 31-12-2011, 12:39 AM
Bookmarks