Thread: Spindle Interference
Threaded View
-
03-08-2016 #1
Hi,
I haven't been around here in a long time, and to be honest I haven't used my crappy old upgraded CNC3020 in ages. Anyway I had a little job to do, so last night i went and fired it up, everything seemed to be working ok until I turned the spindle on, then the Y axis started moving about on it's own.
I have tried a few things but not sure where to go from here...
- Swapped the axis cables at the back of the panel, and it was still the motor plugged into the y stepper driver.
- Swapped the stepper controllers over and still the Y Axis.
- Swapped the data cables on the BOB, still the Y axis
- Rerouted spindle wires as far away from anything else as possible.
In case it's relevant the Y axis always seems to move in a positive direction.
Regards,
Les
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
VFD interference problem
By eurikain in forum General ElectronicsReplies: 81Last Post: 20-03-2016, 11:20 PM -
TB6560 controller Runs spindle on power up When Mach3 plunges spindle stops
By RoyT in forum Spindles & Drive MotorsReplies: 5Last Post: 29-09-2014, 02:42 PM -
Noise, Interference, and unexplained electrical behaviour
By g4ghp in forum General ElectronicsReplies: 4Last Post: 24-04-2014, 11:39 AM -
Bearing interference fit / press fit
By Mad Professor in forum General DiscussionReplies: 5Last Post: 30-09-2012, 11:26 PM -
19inch Rack Enclosure - interference?
By Washout in forum General ElectronicsReplies: 12Last Post: 22-09-2012, 09:10 PM
Bookmarks