Thread: Spindle Interference
Threaded View
-
03-08-2016 #2
Last Activity: 16-02-2019
Not sure if this is the same issue, but on my 6040, if earth cable isn't attached to the frame, the axis will go haywire during a job. Could it be a similar problem?
Bought a Chinese 6040...if only I'd known better :(
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
VFD interference problem
By eurikain in forum General ElectronicsReplies: 81Last Post: 20-03-2016, 11:20 PM -
TB6560 controller Runs spindle on power up When Mach3 plunges spindle stops
By RoyT in forum Spindles & Drive MotorsReplies: 5Last Post: 29-09-2014, 02:42 PM -
Noise, Interference, and unexplained electrical behaviour
By g4ghp in forum General ElectronicsReplies: 4Last Post: 24-04-2014, 11:39 AM -
Bearing interference fit / press fit
By Mad Professor in forum General DiscussionReplies: 5Last Post: 30-09-2012, 11:26 PM -
19inch Rack Enclosure - interference?
By Washout in forum General ElectronicsReplies: 12Last Post: 22-09-2012, 09:10 PM
Bookmarks