Yes I have configured the 3 axis but not the spindle motor, I have tried many configurations with that but to no avail, I have used one of the wizards to make a couple of wood signs, but the z axis (spindle motor) does not travel down the correct depth to the amount you put into the programme and is a bit hit and miss. I now know how to start in the correct position by positioning the spindle motor to a certain position and set the axis to zero also looking at the G codes to see where it will start from the zero position, but I get it wrong sometimes. I now know that I need to learn a cad programme so I can convert a design to G codes, I have tried to do this with a picture then import it to Mach 3 but it did not work. I was hoping I can find a course at my local college but so far that idea has not born fruit.From the beginning of October I will be unable to stand for 6 weeks and then restricted in an air boot for another 6 to 8 weeks, so will not be in the workshop until the new year. I hopeto have some tuition sorted by then