-
20-08-2016 #11
So how is the performance with the original lead screws Clive? can you zero out the backlash in the cross slide?
Thanks A_Camera, yeah I think I will invest in the cable and brake, they are out of stock now so will have to see how long it takes them to restock before I make my final decision. Having looked at the PID in more detail I think you a right and it is more suited to the slower response of temperature control rather than machine spindle control. How does the jog control work? is it like a servo motor for indexing?
Thanks M_C. the motor I was planning to use is an inverter duty 4 pole so should be good from 150 to 3000rpm. 2.2kw specs are:
For Variable Speed use:-
Part Time Output when Inverter powered is...
7.30Nm - 2.2kW ( 2.95HP) x 2880 RPM at 100 Hz
14.59Nm - 2.2kW ( 2.95HP) x 1440 RPM at 50 Hz
14.59Nm -1.1kW ( 1.47HP) x 720 RPM at 25 Hz
14.59Nm - 0.22kW (0.29HP) x 144 RPM at 5 Hz
Continuous Output when Inverter powered is...
10.4Nm -2.2kW ( 2.95HP) x 2016 RPM at 70 Hz
14.59Nm -2.2kW ( 2.95HP) x 1440 RPM at 50 Hz
12.40Nm - 0.94kW ( 1.25HP) x 720 RPM at 25 Hz
7.30Nm - 0.11kW (0.15HP) x 144 RPM at 5 Hz
The lathe is only 125mm centre so not much capacity for large stock and low rpm. I was more looking for indexing at low speed. I will check the cutter forces though.
-
So how is the performance with the original lead screws Clive? can you zero out the backlash in the cross slide?..Clive
The more you know, The better you know, How little you know
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Need help with a sensorless vector VFD and 2.2kw motor.
By kajuk in forum Spindles & Drive MotorsReplies: 42Last Post: 04-06-2015, 10:54 PM -
Need help with a sensorless vector VFD and 2.2kw motor.
By kajuk in forum Spindles & Drive MotorsReplies: 0Last Post: 29-01-2014, 06:09 PM -
bitmap to vector conversion
By GEOFFREY in forum Computer SoftwareReplies: 16Last Post: 29-12-2012, 06:32 PM -
Closed Loop Stepper Compared with Open Loop Stepper
By Leadshine-Erci in forum Stepper & Servo MotorsReplies: 0Last Post: 25-05-2012, 08:11 AM -
Vector graphics AKA CAD for free
By m.marino in forum Computer SoftwareReplies: 1Last Post: 15-01-2009, 02:17 AM
Bookmarks