Epoxy 105 209 questions



What would be a sufficient epoxy thickness and width mounting surface for hiwin type 20mm rail?

My box section is 120x80mm so the flat surface width of the 80mm side
is about 60 mm wide... would 50mm wide and 5 mm thick be enough?

After welding the overall flatness of the frame will be in the +/- 1.5 mm range... so 3.5 to 6.5 mm epoxy thickness after optimum leveling by spirit level..

I am planning to do a single epoxy pouring of the x rail mounting surface and bed supports.. this will give me a good start for a level bed vs x rail

Total needed epoxy amount will be in the 3.0 dm3 range at 5 mm thickness

Verstuurd vanaf mijn SM-A320FL met Tapatalk