Finished. DIY CNC

[Husky1]

Sorry for late reply, been busy.

I am using adaptive toolpaths with Autodesk Inventor HSM. I have used 2 flute, 3 flute, rippers. The only tool i didn't use was 1 flute. I have tested with tools diameter 10mm, 8mm, 6mm and had similar problems. Because of the nature of the workpiece i was mostly using long flute lengths (10mm x 45mm, 6mm x 35mm, 6mm x 20mm). I have tested with short flutes too ofc (10x26,8x20,6x16) and it's the same issue. The machine sound is so loud because the room is very small and echo is really loud on the camera. It's not that bad IRL but its not quite ether . Here is the last batch of broken tools



Doddy, i am not sure if i follow your questions but the frame idea was stolen from Jonathan's machine so i didn't do any calculations to be fair.