Evening All

[Chimestrike]

Thanks for that, can you make any sugestions/recommendations as to good builds I can look into that would do the job I'm your opinion ?

[Robin Hewitt]

I had a look at the OXCNC website but didn't see any numbers for accuracy and repeatability.
Have you found any user reviews? I have found it is always a mistake to search for user feedback after parting with my hard earned.
Can the OXCNC be beefed up? The side rails seem to be enclosed by the gantry bearings, no room for added beef.
OTOH, if you aren't in a rush and do not mind whittling it away, beef is not necessarily necessary.
Is there a worry about dust getting in to those linear bearings? They are completely exposed and wiper free.
You pays your money, you takes your choice.

[mekanik]

Hi Chimestrike
Welcome to the forum
Best bet would be to have a look through the build logs, to give you some idea of decent machines and the work involved, then if you feel you have the required skills to take on a build give Dean(Jazzcnc) a ring and have a crack.
It would be useful if you can weld as steel is going to be the cheapest option,also you don't want to be using a router on the Z axis, far to noisy and will wreck the bearings in no time.
Good Luck
Mike