UCCNC next

Again hardly any information other than a video of threading with a felt tipped pan. The hardware manual is 21 pages long 19 of which tell you how to connect it up to the ethernet port, [ is it THAT hard ? and if it is WHY ? ]
I'm moving from Mach3 to UCCNC for my next router, and just got my UC300ETH the other day. Connecting to the ethernet was very simple. Just go into the adaptor settings on the PC, and enter the UC300 address (10.10.10.10) and subnet. That was all I had to do to connect.

TP from the Mach3 forum is pushing CNC Drive to bring UCCNC to be comparable to Mach3 feature wise. It's already close, and getting better with each release.