DDSCV1.1 3 and 4 axis offline motion controller

[magicniner]

My CNC PC is W7, you'd need your bumps felt to think W10 is a good idea, I'd use Windows 10 if my intention was to develop an unreliable system to prove a negative, ditto unproven external controllers :-)
My CNC System mains supply is via a huge UPS, I bought it with no batteries for £40 and it now runs off a couple of external car batteries ;-)
I haven't had a job stop unexpectedly for 6 to 8 months, the last issue was a broken limit switch wire :D

I believe these boxes offer the huge advantages of not needing a PC/OS/CNC Software, new users will be able to buy one, connect it and simply use it - that's great! It will enable the "Maker Generation" without requiring them to read around the subject and understand their system before they use it.

Reliability improvements will be realised by the unwise and unwary who don't already follow best practice with existing PC/OS/CNC Software/Hardware solutions, all the required information is in the manuals and on the support forum sites, just waiting to be read,

- Nick