Quote Originally Posted by John S View Post
Dean,
Like all devices there will be limitations and I'm thinking that these cheap controllers are for simple one shot machines like a Sieg or Warco X3, WM series mill or simple home built 3 axis router that just reply on 3 + 1 axis and a single spindle, often with ER collet fitting that doesn't allow pre-set tools.

You want more features, you pay your money and move up market to the 990 series controllers.
John I agree with you 100% on most of this but lets be honest and realistic here. Not asking for more features would just like it to do what SHOULD and allow PROPER Tool changes without resorting to messing with writing/modding post processors Etc. It states follows Fanuc standard so it should do it.

This not following standards is what concerns me. What else does it not do.? ie: Canned cycles etc.
It's still on bench without motors etc but I quickly run some code thru it and seemed it didn't like G53 either but without seeing what actually happens when motors connected can't say for sure. Not really good or confidence inspiring start is it.!!