DDSCV1.1 3 and 4 axis offline motion controller

[coolice]

Where you able to get the probe function to work?
It works for me until I clip on to the tool.
Just touching the 2 probe leads together seems to work, but when I clip either lead on the tool it just goes down and stops/binds up.

Hey buddy.

Just an idea, as I've recently got my setup working along with the touch probe, but do you have the polarity of the touch probe wired up correctly?
From memory the ground pin needs to go to the croc clip which clips to your router bit and the positive to the isolated touch puck which sits on the material surface

If you have it the other way around, as the spindle is grounded, connecting a positive wire to it would confuse things.

Ian Contessa