Newbee looking for advice

[JAZZCNC]

Your wasting your time with this design and approach. It's doomed to fail. Far too complicated for no gain and woe fully under built to be any use for cutting anything but chocolate.
I suggest you take step back look around the forum at other builds to get an idea of whats required for good machine.

The simple truth is there is no quick cheap way to build CNC and trying to cut corners will just cost you more money in long run, Happens time n time again. Theres also no point trying to reinvent the wheel or waste time and money with proof of concept. Only so many ways to build router so just look around find what looks and works good then copy or use it for base of your design.

Get looking and do some serious research. DONT BUY ANYTHING other wise 99% chance you'll waste money.