. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #14
    Clive S's Avatar
    Lives in Marple Stockport, United Kingdom. Last Activity: 12 Hours Ago Forum Superstar, has done so much to help others, they deserve a medal. Has a total post count of 3,342. Received thanks 618 times, giving thanks to others 82 times. Made a monetary donation to the upkeep of the community. Is a beta tester for Machinists Network features.
    I spend a couple of years here in Spain repairing PCs as a side job. Number one fault at least 50% in cases=faulty hard drive

    cheap PC for garage =old pc= possible near future hard drive fault.
    Boyan I have a house in Spain for the last 15 years and I know that the electric supply is crap (but is getting better very slowly) that means the electric can go off on a regular basis which is very bad for hard drives as you know. This just does not happen in the UK. I have had hard drives lasting more than 15 years.

    You missed the pun about the Russians! I do think that your comments about the Chinese etc. are really not acceptable to me and probably others as well.

    Cause they are more expensive than the boards could be found
    I was suggesting you put links up for the more expensive ones with good support.

    Now this is the Op's thread and we should not hijack it . My opinion is different to your's so I will leave it as is.
    Last edited by Clive S; 27-09-2016 at 10:51 AM.
    ..Clive
    The more you know, The better you know, How little you know

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Looking into converting my Mill to CNC
    By T0rnado69 in forum Emco Milling Machines
    Replies: 16
    Last Post: 14-02-2019, 12:46 AM
  2. Advice Needed, Converting a Boxford VMC 190
    By Marv2097 in forum Boxford Vertical Mills
    Replies: 17
    Last Post: 19-12-2016, 05:53 PM
  3. converting pdf to cam?
    By motoxy in forum Computer Software
    Replies: 7
    Last Post: 28-02-2014, 08:11 AM
  4. Converting sketchup to dxf
    By motoxy in forum Sketchup
    Replies: 3
    Last Post: 08-07-2012, 12:04 PM
  5. Converting Cardboard to DXF
    By Yow Ling in forum General Discussion
    Replies: 12
    Last Post: 15-11-2010, 10:18 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •