Thread: Advice on converting my VMC
Hybrid View
-
26-09-2016 #1
Hello Boyan, and thanx for reply :-)
Yes, i have been looking at these controllers.
Found several of them at ebay like this one http://www.ebay.com/itm/English-Pane...oAAOSwG-1Wy-32
Dont mind being a guinea pig, but my experience in programming CNC is not exactly fierce. Which means i would like to start with making the drawings and run it from there(that i do have some experience with).
In time i want to start playing around with the programming part in depth.
Right now i follow my old KISS(Keep It Simple Stupid) theory, trying to find a cost effective solution i can start with.
However, manuals have been downloaded some time ago and i will attempt to study this in due time.
-
26-09-2016 #2
3 Axis even a bit cheaper.
http://www.ebay.com/itm/English-Pane...3D331785938231
-
26-09-2016 #3
Chaz,
I apologize if my question can seem somewhat stupid, but how do i control the 4/5th axis cradle if i install a 3 axis controller ?
Jupp.. I`m a newbie :-)
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Looking into converting my Mill to CNC
By T0rnado69 in forum Emco Milling MachinesReplies: 16Last Post: 14-02-2019, 12:46 AM -
Advice Needed, Converting a Boxford VMC 190
By Marv2097 in forum Boxford Vertical MillsReplies: 17Last Post: 19-12-2016, 05:53 PM -
converting pdf to cam?
By motoxy in forum Computer SoftwareReplies: 7Last Post: 28-02-2014, 08:11 AM -
Converting sketchup to dxf
By motoxy in forum SketchupReplies: 3Last Post: 08-07-2012, 12:04 PM -
Converting Cardboard to DXF
By Yow Ling in forum General DiscussionReplies: 12Last Post: 15-11-2010, 10:18 AM
Bookmarks