My apologies Jazzcnc. I assumed most of you guys knew these steppers and drivers already. My fault.
I do know the difference between the C11 and the CSMIO/IP-S. Just tryed to reduce cost. Besides i was curious about your experience with the DM860A drivers
and 34HS9805 steppers from Longs-Motors vs European or US "made" drivers and steppers.(Link below).
Did take a look at the Hicon Integra as well, but i have already decided on the CSMIO/IP-S. It`s more expencive, but it pays off in the long run.
As for drivers, i have 3 KL-8056D drivers in house and will make use of them. As for steppers, i have chosen 3 KL34H260-35-4A.
These are 3,5Amps 465oz.in steppers and 5,6Amp(peak) drivers. Will choose 2(maybe 3) x 24Vdc/8,3Adc Switch mode PSU to keep noise down.
I do beleive i will have a good system with this choice, but please feel free to comment if you see something wierd :-)
Links:
KL-8056D driver: http://www.automationtechnologiesinc...nk-is-included
KL34H260-35-4A stepper: http://www.automationtechnologiesinc...nk-is-included
Hicon Integra: http://www.automationtechnologiesinc...ler-industrial
KL-201-24 PSU: http://www.automationtechnologiesinc...pply/kl-201-24
DM860A driver: http://www.longs-motor.com/productin...12_80_137.aspx
34HS9805 stepper: http://www.longs-motor.com/productin...12_25_120.aspx