Community Project: Fender Telecaster

[ericmac]

Hi Eric

Shoot me a PM with the email address you used to register to Fusion 360 and I'll give you access to the project - be very aware though that the CAM that's there is "tuned" to my machine so its best to take a copy of the CAD and do your own with feeds and speeds for your machine.

Cheers


Chris

Not sure if I already sent this to you... lll run my own cam, thanks a ton for the cad! Great videos! Please keep it up.




Sent from my iPhone using Tapatalk

[Washout]

Hi Eric

Good man - I seem to be getting a lot of requests for the CAM, from the uninformed that think they can load my GCode and press start on an X-Carve. That will only get them a floor full of broken machine parts if they try milling at 15mm depth on an 8mm cutter

Best to delete the email addresses off of your post there - bots will be picking those up and phishing will commence (Lee might be able to do this if he picks up on it first).

Cheers


Chris

[ericmac]

Hi Chris,
I haven't been able to find any files on A360 under either account? Is it shared through the fusion? Also, thanks for the HU regarding the email addresses!
Best,
Eric

[Washout]

Hi Chris,
I haven't been able to find any files on A360 under either account? Is it shared through the fusion? Also, thanks for the HU regarding the email addresses!
Best,
Eric

Hi Eric

That should be fixed now - not sure why but it was failing to send the invite to you silently i.e. no warning. Anyway should be there now, so let me know if it hasn't worked again.

Cheers

Chris