Quote Originally Posted by Nickhofen View Post
Nice work, I notice that you didn't heat the binding prior to bent it at the area of lower horn, this mean the binding is soft enough for this job, right? What kind of plastic is made of? ABS? also I have seen people bond the binding with the body with acetone, they say it is a more clean work. I haven't try that... only just CA glue.
Yes it was fine for the lower horns, it was only on the right angle bend under the neck pocket that really needed heating.

I think its ABS, but it was off of ebay so you can never be 100% sure...

I have some decent glues and of course acetone, but I find the bonds can be a little weak and CA is just a lot quicker in general but does have that "one shot" risk.