Thread: Mach 3 behaving badly?
Threaded View
-
04-10-2016 #24
It is a must to install a version supported by any third party hardware you use, if that isn't a requirement then the version quoted above is what most of the very experienced Mach3 Forum Admins recommend.
The latest version of Mach3 is not best, it's buggy, and knowing this then unless you need it to support something you are using or doing why on earth would you use the latest version of Mach3?
There are some things that other versions do best, the Mach3 forum is the place to find out the best version for any specific requirements you have, sometimes it's a slightly older version than 020! Again, assuming that latest is greatest is a recipe for problems.
Errors generated only when third party hardware is used cannot be laid at the door of Mach3, it is the sole responsibility of the third party to ensure their plugin runs seamlessly with Mach3 and it is entirely the fault of the third party if they do not,
- NickYou think that's too expensive? You're not a Model Engineer are you? :D
-
The Following 3 Users Say Thank You to magicniner For This Useful Post:
Thread Information
Users Browsing this Thread
There are currently 11 users browsing this thread. (0 members and 11 guests)
Similar Threads
-
MACH 3 requirements
By manofgresley in forum Artsoft Mach (3 & 4)Replies: 14Last Post: 08-01-2020, 07:22 PM -
Mach 3 Help
By RichardR in forum Artsoft Mach (3 & 4)Replies: 2Last Post: 04-08-2016, 12:21 PM -
RFQ: Triac / Mach 3 help
By suesi34e in forum Projects, Jobs & RequestsReplies: 0Last Post: 10-08-2013, 01:59 PM -
mach 3 help
By 1albobs in forum Artsoft Mach (3 & 4)Replies: 3Last Post: 27-02-2012, 03:34 PM -
MACH 2008
By Lee Roberts in forum General DiscussionReplies: 5Last Post: 05-10-2007, 09:48 AM
Bookmarks