photvcarve finishing techniques

[Boyan Silyavski]

Hi,
What program exactly do you use?

The way you have done it, its very difficult to say. I would say do it again.


The way you have done it its a kind of mixture between 3d and Vcarving.


If it was pure 3d like:




You would need just to fine sand it.


If it was pure V carve like:



then clean with plastic brush and sand it



Both could be sealed linseed oil, tung oil or polyurethane or epoxy.


Now i don't want to discourage you but as i am a sincere one, just do it again. I think it could be done better. My advice is:

-don't be in a hurry and pre visualise it better in software
-do a test small pieces until you are happy, then the big piece.
-search similar stuff and see how others do it/ Vectric forum/
-its and art, so there will be mistakes at first
-V carve is mainly for 3d lithophanes that are backlit, so it takes even more to do it properly the way you intended to do it.
-that above is the only good result i found in Google search, so that should be your starting point to compare what you are doing
-In a imaginary business, if you are not ready to pay money for your final result, then its still not good enough