SSO/FRO (Spindle Speed/Feed Rate Override)

[Boyan Silyavski]

I don't understand exactly what you are talking about, but if you are talking and thinking about the chinese controllers, i have to clarify that-if the spindle is not a servo motor but HF spindle-then its best to make default frequency 10 000 and use SRO on panel. 2 benefits of that- its easier to adjust voltages on the VFD and thus the spindle speed at all speeds is more correct. Plus the override on the board i am testing is 10% 20%, etc, so 100 is easy to divide by 10 and usually 16000 rpm are programmed not 1575 rpm.
Hope that makes sense.

At the other hand its better to have an encoder. Especially if you don't like to change tools and do 2 or more different HSM operations with the same tool. Which will require to stop and change the tool and speed change. But if an encoder is fitted, then you could cheat by stop. change nothing but speed automatically from program and then continue with another/ the same actually/ tool. Recently i am doing quite a lot of that. Still the stupid way though.

[m_c]

The controller would be a Dynomotion KFlop, so I have lots of flexibility in programming.
.
I still need to run through a list of inputs/outputs for this machine, as if I allow for how I ultimately want to upgrade this machine to, then I may only have one encoder input spare, unless I move some of the differential inputs to other inputs (I've got a Kanalog, so the differential encoder inputs can be used as standard differential inputs).
.
I've had a reply from the man behind Dynomotion, and he said either way would work fine, and if noise was an issue with a pot, just fit a bigger capacitor over the input wires, as you don't need that fast a response.
.
If I was to use pots, then I could have an option for it to either go straight to the pot setting, or not to move until the pot is returned to near zero.
.
Sometimes lots of options isn't good!
I've got a few other more pressing issues to deal with, so I've got plenty time to think about this.

[JAZZCNC]

KISS every time. Why use expensive encoders when pots work.

Both SSO/FRO are invaluable to me for getting the best out of machine and G-code. Equally they have saved my bacon many times when I cock up in code and when working with materials like Ali they are priceless when hit hard soft spots which happens lots on cheaper softer grades.

Certainly worth taking the time to get right.

[Boyan Silyavski]

KISS every time. Why use expensive encoders when pots work.

Both SSO/FRO are invaluable to me for getting the best out of machine and G-code. Equally they have saved my bacon many times when I cock up in code and when working with materials like Ali they are priceless when hit hard soft spots which happens lots on cheaper softer grades.

Certainly worth taking the time to get right.

I couldnt help but imagine this:

[JAZZCNC]

I couldnt help but imagine this:

No you don't quite get the KISS approach I mean.? . . . . .My KISS would have been to throw it out the window.!