ROLAND CAMM-2 PNC-2300A Conversion?

**John S** · 24-10-2016

No idea I'm not into garbled boards and arduino's

**Chimestrike** · 24-10-2016

Fair enough lol, so if I went for a mach3 board with stepper drivers and then removed the standard control board and wired straight to the mach board which I'm assuming is the same principle?

**m_c** · 25-10-2016

Yes.
However, any kind of board with inbuilt drivers will usually not be ideal. Certainly the older TB based boards were pretty unreliable, however I suspect given this application you won't be pushing the stepper driver chips that hard, so it shouldn't be a problem. Most problems seemed to occur when people were trying to push the boards to the voltage/current limits.
.
GRBL with suitable stepper drivers would work, but you'd need to see if it will do what you need it to. Although I've looked at GRBL, it was only a quick look a while ago, so I have no idea of it's current capabilities.

**Chimestrike** · 25-10-2016

To be honest it's not going to be doing hard work its mainly going to be a bit of engraving and some pcb work mainly with the odd bit of thin cutting, so I would guess its not going to have a hard life in that respect. It's mainly to overcome the fact that 'dr engrave' while being great for the early 90's is a bit useless now and well I want to keep the machine going and this seemed a good plan.

GRBL would be good as I have a board, but I really don't know as both will do the job and it's really going to be for my hobby builds so nothing too critical as such.

**Chimestrike** · 25-10-2016

I've just seen a diagram that has cleared this all up for me in respect of controller and driver boards, sorry all was being a bit dense

**Lee Roberts** · 25-10-2016

Hey if you dont know, you dont know!

At least now you do know and can help the next man when he comes along needing help :).

Good luck with the conversion, dont forget to do a build log so we can see your progress and success.

**magicniner** · 25-10-2016

On the subject of integrated Break-Out and Driver boards, if you buy one integrated lump that does everything then the whole thing may be scrap in the event that one part of it fails, if you use separates then you can swap out one bad part in the event of failure, swapping over to fault find if required,

- Nick