Sorry, did not get time to do the photo's last night, I went in the workshop and said to missus "I will only be an hour.." four hours later I was still going..!

Anyway. here are the photo's -







Powder coated finish, the colour was what he was painting at the time and actually I quite like it!

The spare XLR connector holes are for limit switch's and 4th axis. Power connector on front is the in/out for the spindle motor, power in is on the rear. 80mm fans front and rear for cooling, sucks the air in at the front and exhausts at the rear.

I have put 10mm standoffs in were all the boards fit so its just a case of screwing them in and wiring up, dead easy!