CNCdrive UC300ETH Mach3 plugin is now available

[Lee Roberts]

The UC300ETH basically has 5 parallel ports. There are different motherboards available which dictate the input and output pins.
Two ports are standard, and 3 ports use pins 2-9 as inputs.
The CNC4PC M44 board has 3 parallel ports, and two special ports, one for inputs, one for outputs. One of the 3 is standard and two use pins 2-9 as inputs.

You plug in your breakout boards and wire it any way you want, just like a standard parallel port.

The analog I/O uses a separate header.

There is no lathe screen at this time. It does rigid tapping, so it may be able to use a multiline encoder. Not positive, though. Send them an email, they are very good with customer service.

What's your hardware setup Gerry ?

I'm confused, so do you need to buy a motherboard or dose it come with the one in the pic and shown in the manual?