CNCdrive UC300ETH Mach3 plugin is now available

[JAZZCNC]

Its probably just the evolution of the product and so on, USB is 5v, allot of hobby guys have for years/probably run 5v systems, they probably didn't expect the need to cater for such professional setup's like the ones you build.

That's just it Lee it costs so little extra for these guys to do it right. It shouldn't be considered Professional level. It should be a standard for CNC.(To save loss of hair.!!)
Only reason they don't include on the Mainboard is so they can sell BOB's.!!!!

Does look an interesting device, though, and if I weren't building in a CSMIO I might have considered one - plus the extra boards for opto-isolation, etc.

Neil while it's nice board there's no way I'd swap for Cslabs IP-M other than to use there UCCnc software. If using Mach3 then it's still got long way go to compete with the quality of Cslabs units.
Not until they dump the requirement for external BOB or Isolation and provide 24v I/O and remove the need for 5v psu would I consider using them, even if the UCcnc software is better than Mach3.

If Cslabs would just change there policy and allow independant homing of the Slaved axis for router/plasma type machines they would blow every other PC based Motion controller at this level away. Can't believe they don't see the potential sales there losing because lack of this one feature and believe me I have told begged and pleaded with them on many occasions.