CNCdrive UC300ETH Mach3 plugin is now available

[Ger21]

The UC300 has 12V outputs, as well as 0-10V

I don't think it has 12V outputs, because it connects to standard parallel port breakout boards.
Also, I think the analog voltage varies depending on which motherboard you use, and I don't think it does 0-10V without a breakout board, does it?

[Ger21]

You are correct about the 0-10V output. I was confusing them with the analog inputs.

The 12V outputs on the analog port are not "outputs", but just 12V.

The UC300eth also has a 400Khz kernel speed.

[A_Camera]

You are correct about the 0-10V output. I was confusing them with the analog inputs.

The 12V outputs on the analog port are not "outputs", but just 12V.

The UC300eth also has a 400Khz kernel speed.

Yes.... well, it is an output, but yes it is just 12V. On when the card is powered up off after power off and in between it outputs 12V on those pins.