-
25-12-2016 #31
Say what with the who now!? There are always wheels within wheels with this hobby. How do I pierce at a slope!?
-
25-12-2016 #32
Your slot drill is bound to chew up the metal directly below it's centre, it is just something they do. A milling cutter has no cut towards the middle so it can leave a fine finish below. They all have their tricks.
However a milling cutter can only plunge vertically so far before it's non-cutting middle bottoms out, so you have to move sideways as you move downwards to remove that middle.
Well, either that or restrict your Z travel to what it can manage
-
25-12-2016 #33
Ah, I always climb into the cut so I should be able to end-mill. But I thought a slot-mill and an end-mill were essentially the same things these days? How would I know I was buying a true end-mill that gave me a smooth bottom. So to speak.
-
25-12-2016 #34
You "pierce at a slope" by using the ramped or spiral lead-in options in your CAM package.
Clods have muddied the water on cutter nomenclature but there are always centre-cutting and non centre-cutting tools, Slot Drill used to refer to a centre-cutting tool capable of plunging (Drilling) and End Mill to a non centre cutting tool,
- NickYou think that's too expensive? You're not a Model Engineer are you? :D
-
25-12-2016 #35
Ah, Ok, so I want a non centre-cutting mill to achieve a good finish on my bottom? The terminology seems a bit weird to me as a thing that cuts a 'slot' I would have assumed to be good at cutting on the side (slots have walls), rather than the end, while the 'end' mill sounds as though it _should_ be good at cutting on the end. But I suppose it is good at 'milling' on the end, rather than 'cutting'? Bugrit, I'll stick with centre-cutting or non centre-cutting, that's at least a single term that can be positive or negative to conjure with.
Last edited by Rob Meades; 25-12-2016 at 05:23 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Smooth finish with v bit on mdf
By Skydeals in forum General DiscussionReplies: 7Last Post: 16-10-2015, 10:28 PM -
how to smooth stl model, smooth curves out of straight lines
By chris in forum DeskProtoReplies: 4Last Post: 21-01-2014, 11:00 PM -
Creating .TAP files in Mach3
By Ahmed in forum Artsoft Mach (3 & 4)Replies: 3Last Post: 23-11-2013, 09:51 AM -
FOR SALE: milling slot cutter 20mm new for sale
By chalfontcrew in forum Items For SaleReplies: 0Last Post: 04-02-2013, 12:18 AM -
Creating Local group/club???
By m.marino in forum General DiscussionReplies: 0Last Post: 02-07-2010, 11:03 AM
Bookmarks