Breakout Board expandability...CNCdrive based control system

[JAZZCNC]

I think CNC Drive, like CNC Room, are afraid of spending all the time developing a quality board, and finding out that they don't sell any.
But if you build a quality product, and let people know about it, you'll sell a lot of them.

Quality product that works and well supported will always sell them selfs. If they provided board with the No Frill features this one does and at sensible price then I can't see how they won't sell and cause lot of other manufactures lots to think about.
IMO between there software and Hardware Combo they could wipe out few manufactures like Warp9 and seriously give Artsoft problems, if not wipe them out in the Hobby department. (Which lets face it Brian is doing Job of Himself.!!)