Thread: Spindle being awkward.
Hybrid View
-
27-11-2016 #1
Stick a meter across the 0-10V and see what that says?
If you're getting voltage drop then it's the output from your BOB so stick the meter across the power supply to the BOB and see what that's doing.
- NickLast edited by magicniner; 27-11-2016 at 02:28 PM.
You think that's too expensive? You're not a Model Engineer are you? :D
-
27-11-2016 #2
Need more info.
Parallel port or Motion controller.?
What spindle speed controller/BOB.?
What terminals have you connected to on VFD.?
Pics always help.!Last edited by JAZZCNC; 27-11-2016 at 02:52 PM.
-
27-11-2016 #3
Thanks Dean
I have Ess connected to cheap bob similar/same to the ones Emvio Eng recommend.
This picture shows spindle running 12000rpm 4.14 volts at the vdf connections, so looks to me like the relay is misbehaving ?
Sorry despite trying for half an hour I cannot get pics to upload, if needed will try from my house later.
Mick
-
27-11-2016 #4
PS have checked connections FOR-DCM and V1-ACM checked and double checked.
When rapiding around there is no volt drop.
Mick
-
27-11-2016 #5
have you set the Pulley ratios.?
-
27-11-2016 #6
Dean
Pulley no4 max speed 24k ratio 1
Mick
-
27-11-2016 #7
Have set decel quite high and under mdi stops quick it is the same under jog and program.
-
28-11-2016 #8
Hey are we talking about the spindle or Motor tuning here.? They should have no affect on each other.
Jog should not affect the spindle in anyway what so ever. Similiar in MDI only commands that should affect Spindle is M3/M4/M5 and S (speed).
Asked before can you post picks or show drawing of exactly how you connected because something is very wrong.
Also Either show how you have Mach3 setup or Zip up your XML file so can take look.
-
28-11-2016 #9
-
27-11-2016 #10
This might help I am getting 23.5v across the FOR connector on the vdf when I press jog.
Thread Information
Users Browsing this Thread
There are currently 3 users browsing this thread. (0 members and 3 guests)
Similar Threads
-
Chinese 300W DC spindle - is the spindle shaft grounded?
By HankMcSpank in forum Spindles & Drive MotorsReplies: 44Last Post: 26-11-2016, 07:25 PM -
TB6560 controller Runs spindle on power up When Mach3 plunges spindle stops
By RoyT in forum Spindles & Drive MotorsReplies: 5Last Post: 29-09-2014, 02:42 PM -
CNC Spindle Repair and Spindle Replacement for any Machine of any Manufacturer
By spindeldoctor in forum Manufacturer NewsReplies: 0Last Post: 13-11-2013, 07:50 PM -
Spindle lock mechanism for 2.2kW china spindle
By Jonathan in forum Generic Chinese SpindlesReplies: 8Last Post: 13-08-2012, 08:39 PM -
DIY Spindle - What type of bearings are best suited for a spindle.
By 8iggles in forum Spindles & Drive MotorsReplies: 18Last Post: 09-02-2011, 10:15 PM
Bookmarks