Project Beaver

[JoeHarris]

Looking good though - are you planning on including any bracing or haunches?


Sent from my iPhone using Tapatalk

[OMLCNC]

I'd give yourself a bit more room against the wall if you can... I have built mine too close as I have maxed out the size of machine for my tiny workshop - it's a pain in the ass not being able to get to all sides!

Yes Joe, I will be giving it a bit more room, I have more clearing and moving to do to make space, you will see as the build progresses where it will end up. Plus you need room to role the frame over to carry out the welding. I'll be moving it around on a pallet truck as well until it ends up its final position as I expect I will have to take a break from building it, to do some work in the workshop.

Looking good though - are you planning on including any bracing or haunches?

Thanks, yes as per the drawing, today was just a trial clamp it all together and marking out day , its all dismantled again for drilling and tapping and welding ends and feet plates

[OMLCNC]

Christmas has come early. "Our Man in China" has delivered on the order.
Well done Mr Fred Lee all present and correct.

[JAZZCNC]

Excellent so should be done for 1st Jan . . .

[OMLCNC]

Excellent so should be done for 1st Jan . . .

You don't say what year? Probably by 1st Jan 2018

[OMLCNC]

Bit of a redesign due to cocking up the order for the length of the RM2020 1400mm should have been 1500mm long.
Hope I can still get 1/4 sheet cutting area (1220mm x 610mm)